Wire Soap Multicutter

£189.00

Wire Soap Cutter to cut 12 slices of 1 inch wide soap at a time. Made from top quality birch ply sourced from sustainable forests. The cutter is varnished in one coat of clear varnish and has twelve wires attached to six turning keys. The cutter is supplied with one spare wire. 

This cutter has been tested on Cold Process Soap and the soap needs to be cut soon after de-mould, however very soft soap may need to be left a while before it is cut for best results. The cutter has not been tested on M&P soap and these cutters are not designed for very hard soaps as this may cause the wires to snap. For soap with fancy tops it is best to place your soap on one side for cutting to avoid damage to the top of the soap. 

Once the cutter has sliced through your soap do not try to bring the cutter back up again but leave in the downwards position and remove your soap slices. 

Approximate Measurements. Width of base: 40cm. Height: 20cm. Depth: 34cm.

The white cutting plate measures approximately: 12cm deep and 32.5cm in length. The plastic plate which is designed in a material able to withstand chemicals can be easily brushed with a paintbrush to clean or removed and hand washed.The wires need to be cleaned after each use.

The top half of the cutter is very heavy with most of the weight in the top half of the cutter and so care needs to be taken not to allow the top half of the cutter when in the upright position to be pushed back or to fall back. 

Sold Out
  • Shipping Weight: 18Kgs
  • 0 Units in Stock


Current Reviews: 1

This product was added to our catalogue on Tuesday 05 November, 2013.

Your IP Address is: 54.221.147.93
Copyright © 2018 The Moulds Shop. Powered by Zen Cart. Website by : Sloan IT Services