Mould Divider to fit #2 Silicone Mould Liner

£8.49

Divider to fit the #2 silicone mould liner. This is a three cavity HDPE divider with two end pieces and two dividers. This divider can be used to achieve many different designs in your soap. Please note that the divider needs to be removed before the soap sets.

Measurements: End pieces: 8cm wide by 7.5 cm tall. Dividing strips: 7.6 cm tall by 21.6 long. These measurements are approximate and remember that the dividing strips fit into the end pieces so the overall length will be slightly shorter. 

These have been designed to fit only into our silicone mould liners and where the fit isn't perfect the plastic can be sanded down carefully if required. All of our products are hand made and not factory manufactured. These are not suitable for use in an oven. Please note thet these dividers may not work where the mould liner is not suitably supported.

Add to basket:

  • Shipping Weight: 0.27Kgs
  • 3 Units in Stock


This product was added to our catalogue on Wednesday 21 August, 2013.

Your IP Address is: 54.158.208.189
Copyright © 2018 The Moulds Shop. Powered by Zen Cart. Website by : Sloan IT Services